|
|
TM 9-2320-366-20-1
CONTINUITY TEST
NOTE
Install plastic cable ties as required.
(1) Position front grille on cab with washer and
screw.
(2) Position two washers and screws in front
grille.
(3) Tighten screw to 48-60 lb-in. (5-7 N.m).
(4) Tighten two screws to 24 lb-in. (3 N.m).
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter to
terminal lug TL48.
(7) Connect negative (-) probe of multimeter to
terminal lug TL62 and note reading on
multimeter.
(8) If continuity is not present, go to step 8 of
this fault.
Change 1
2-266.3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |