 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
CONTINUITY TEST
(1) Disconnect batteries (para 7-57).
(2) Remove kick panel (para 16-3).
(3) Disconnect connector clamp from
connector P115.
(4) Disconnect connector P115 from WTEC III
transmission ECU connector.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to relay K26 socket 86.
(7) Connect negative (-) probe of multimeter to
connector P115 socket 8 and note
reading on multimeter.
(8) If continuity is not present, repair wire 123
from relay K26 socket 86 to connector
P115 socket 8 (para 2-45) or replace
WTEC III dashboard cable assembly
(para 7-11).
(9) Connect connector P115 to WTEC III
transmission ECU connector.
(10) Connect connector clamp to connector
P115.
(11) Install relay K26 in PDP.
Change 1
2-257
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals