 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
CONTINUITY TEST
(1) Remove instrument panel for access
(para 7-15).
(2) Disconnect connector J114 from WTEC
II transmission ECU pushbutton shift
selector (TEPSS).
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to connector J114 socket 23.
(5) Connect negative (-) probe of multimeter to
connector J116 socket D1 and note
reading on multimeter.
(6) If continuity is not present, replace WTEC II
cab transmission wiring harness
(para 7-137).
(7) If continuity is present, replace WTEC II
transmission ECU pushbutton shift selector
(TEPSS) (para 8-2).
(8) Connect connector J114 to WTEC II
transmission ECU pushbutton shift selector
(TEPSS).
(9) Install instrument panel (para 7-15).
(10) Connect connector J116 to VIM connector.
(11) Tighten screw on connector J116.
(12) Install kick panel (para 16-3).
(13) Connect batteries (para 7-57).
Change 1
2-251
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals