 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
CONTINUITY TEST
(1) Disconnect batteries (para 7-57).
(2) Loosen screw in connector PX33.
(3) Disconnect connector PX33 from VIM
connector.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to neutral start relay socket 87 on VIM.
(6) Connect negative (-) probe of multimeter to
VIM connector PX33 pin F1 and note
reading on multimeter.
(7) If continuity is not present, replace WTEC II
vehicle interface module (VIM) (para 8-6).
(8) Install neutral start relay in VIM.
(9) Install cover on VIM with metal seal ring,
eight washers, and screws.
(10) Install circuit breaker CB35 in PDP.
Change 1
2-245
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals