 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove three screws and washers from
PDP.
(2) Remove three screws from PDP.
(3) Lift PDP outward to gain access.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to relay K11 socket 30 on PDP.
(6) Connect negative (-) probe of multimeter to
terminal board TB1 position 64 on PDP and
note reading on multimeter.
(7) If continuity is not present, repair wire
1658 from relay K11 socket 30 on PDP to
terminal board TB1 position 64 (para 2-45)
or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8) If continuity is present, repair wire 1929
from circuit breaker CB77 socket 5 on PDP to
terminal board TB1 position 64 (para 2-45)
or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III dashboard
cable assembly (para 7-11).
(9) Install PDP on dashboard with three screws.
(10) Install three washers and screws in PDP.
(11) Install relay K11 in PDP.
(12) Install PDP cover (para 16-2).
(13) Connect batteries (para 7-57).
Change 1
2-211
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals