CONTINUITY TEST - TM-9-2320-366-20-10313

TM 9-2320-366-20-1

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes. Failure to comply

may result in damage to equipment.

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability. Check that

connector pins are not pushed back or not

capable of making good contact.

CONTINUITY TEST

(1) Set multimeter to ohms.

(2) Connect positive (+) probe of multimeter to

connector P34 pin 1.

(3) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(4) If continuity is not present, go to step 20 of

this fault.

Change 1

2-183