 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Diesel fuel is flammable. If fuel is spilled,
clean it up immediately. Failure to comply
may result in serious injury or death to
personnel.
STE/ICE-R TEST #50
(1) Remove plug from tee fitting on outlet
side of fuel filter base.
(2) Remove adapter fitting from tee fitting on
inlet side of fuel filter base.
(3) Install plug in tee fitting on inlet side of
fuel filter base.
(4) Install adapter fitting in tee fitting on
outlet side of fuel filter base.
(5) Prepare STE/ICE-R Test #50
(TM 9-4910-571-12&P) to adapter fitting.
(6) Start engine (TM 9-2320-366-10-1).
(7) Perform STE/ICE-R Test #50 (TM 9-4910-
571-12&P).
(8) Raise idle speed to 2000 rpm for 10
seconds.
(9) Pressure should read between 39 psi and
58 psi.
(10) Record test results.
(11) Shut down engine (TM 9-2320-366-10-1).
(12) If test results indicate more than 10 psi
pressure difference from results of step 5
of this fault, replace fuel filter (para 4-14).
(13) Disconnect STE/ICE-R from adapter fitting.
(14) Remove adapter fitting and preformed
packing from tee fitting. Discard
preformed packing.
(15) Remove plug and preformed packing
from tee fitting on inlet side of fuel filter
base. Discard preformed packing.
(16) Install preformed packing, adapter fitting,
and plug in tee fitting on inlet side of
fuel filter base.
(17) Install preformed packing and plug in tee
fitting on outlet side of fuel filter base.
(18) Lower cab (TM 9-2320-366-10-1).
Change 1
2-108.7/(2-108.8 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals