Installation - TM-9-2320-279-20-10568

TM 9-2320-279-20-1

Fuel System Maintenance Instructions (Cont)

4.10. FUEL-WATER SEPARATOR REMOVAL/REPAIR/INSTALLATION (CONT).

e. Installation

(1)

Install two preformed packings (1) on elbows (2 and 3).

(2)

Install two elbows (2 and 3) on fuel-water separator (4).

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. lb avoid injury or death, keep away from open fire

and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or

clothing, wash immediately with soap and water.

(3)

Coat threads of elbows (2, 3, 5, and 6) with pipe thread sealing compound.

(4)

Install elbows (2 and 3) to elbows (5 and 6).

(5)

Connect fuel lines (7 and 8) to elbows (2 and 5).

NOTE

There are two models of fuel-water separators. Model A has two wires connected at the

bowl. Model B has two wires at the back of the cylinder ring. Do step (6) for Model A. Do

step (6.1) for Model B.

(6) Connect electrical wires (9) to terminals (11) in fuel-water separator (4).

(6.1) Connect fuel-water separator wire (9.1) to harness wire (9.2) with connector (9.3).

NOTE

Ground wires and lockwasher should be installed on bottom right screw.

Some vehicles have nuts, lockwashers, and screws. Others have flanged nuts and

screws.

(7)

Attach fuel-water separator (4) to tire carrier (12) using four screws (13), two lockwashers (14),

ground wire (10), four washers (15), three lockwashers (16), and four nuts (17).

4-40

Change 3