 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-34-2-3
h.
Replacement.
FRAME 1
Soldier A 1.
Lower hoist cable (1) through opening in bottom of tool compartment (2).
Slide power divider and crane drive assembly (3) into position below
Soldier B 2.
truck. Join hook on hoist cable (1) to power divider lift ring (4). Guide
power divider and crane drive assembly as soldier A raises it.
Using hoist, raise power divider and crane drive assembly (3) into place.
Soldier A 3,
Hold two nuts (5).
Soldier B 4.
Put in, but do not tighten, two front mounting screws (6).
Soldier A 5.
NOTE
Follow-on Maintenance Action Required:
Replace power divider-to-hydraulic hoist pump propeller
1.
s h a f t . Refer to TM 9-2320-211-20,
R e p l a c e input propeller and winch propeller shafts.
2.
R e f e r to TM 9-2320-211-20.
R e p l a c e pump propeller shaft-to-power divider dust
3.
b o o t . Refer to TM 9-2320-211-20.
Replace transfer-to-power divider propeller shaft,
4.
Refer to TM 9-2320-211-20.
R e p l a c e power divider-to-winch propeller shaft. Refer
5.
to TM 9-2320-211-20.
R e p l a c e power divider linkage. Refer to para 17-53.
6.
7.
R e p l a c e control valve assembly. Refer to para 17-51,
F i l l power divider assembly as given in LO 9-2320-211-12.
8.
C h e c k power divider assembly for proper operation.
9.
R e f e r to TM 9-2320-211-10.
END OF TASK
17-770
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals