 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-34-2-3
There are no special cleaning procedures needed. Refer to
c. C l e a n i n g .
c l e a n i n g procedures given in Part 1, para 1-3.
d. I n s p e c t i o n a n d R e p a i r .
( 1 ) Check that all threaded parts have no stripped or damaged threads.
(2) Check that all control rods have no bends or cracks.
( 3 ) Check that all cross shafts are not bent, cracked, burred or worn.
( 4 ) Check that all cross shaft support brackets have no cracks. Check
t h a t bores are not burred or worn.
(5) Throw away damaged parts and get new ones in their place. If control
rods or cross shafts are bent, repair by straightening. Refer to FM 43-2.
e. A s s e m b l y .
(1) Control rods and clevises.
FRAME
1
1.
S c r e w on nut (1).
2.
S c r e w on clevis (2) with same number of turns as tagged. Take off tag.
Hold clevis (2).
T i g h t e n nut (1) against clevis.
3.
D o steps 1 through 3 again to put clevises (2) on other two control rods.
4.
END OF TASK
17-284
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals