Lever shaft stud in cam groove.

TM 9-2320-211-34-2-2

(2) Lever shaft stud in cam groove.

Remove drag link at pitman arm. Refer to TM 9-2320-211-20.

Loosen screw (1) in clamp (2) on steering jacket (3).

Unscrew adjusting screw locknut (4).

NOTE

Do not do this adjustment if steering wheel (5) is not set in

position in step 4. A false adjustment will be made if steer-

ing wheel is not set correctly.

Turn steering wheel (5) all the way to left. Turn steering wheel all the way to right,

counting number of turns. Turn steering wheel to left one-half the number of turns

counted.

T i g h t e n adjusting screw (6) with thumb and forefinger until a slight drag

i s felt when turning steering wheel (5).

Hold adjusting screw (6) and tighten adjusting screw locknut (4). Be careful not to

change adjustment.

Check drag through full travel of steering wheel (5).

Tighten screw (1) in clamp (2).

Replace drag link on pitman arm. Refer to TM 9-2320-211-20.

END OF TASK

13-64