|
|
TM 9-2320-211-34-2-1
NOTE
S h i m s (1) are used to set bevel pinion gear tooth depth.
Use same shims taken out in disassembly the first time
g e a r tooth depth is checked.
P u t needed number of shims (1) in place on gear side of retainer assembly (2).
1.
2.
S l i d e drive shaft assembly (3) with shims (1) into bore in differential carrier
a s s e m b l y ( 4 ) . L i n e up bearing inner race (5) with bearing (6).
L i n e up holes in shims (1), retainer assembly (2), and differential carrier
3.
assembly (3).
S e a t drive shaft assembly (3) with shims (1) against differential carrier
4.
assembly (4).
P u t in eight screws (7) with flat washers (8).
5.
GO TO FRAME 11
9-51
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |