FRAME 2 - TM-9-2320-211-20-3-20526

TM 9-2320-211-20-3-2

FRAME 2

Using screwdriver, screw in and tighten two screws (1) through windshield

frame (2) into wiper motor (3).

2. Clip wiper blade (4) to wiper arm (5).

3. Using pliers, slide washer (6) onto serrated shaft of wiper motor (3).

4. Put wiper arm (5) on serrated shaft of wiper motor (3). Set arm so that blade

clears windshield center post (7).

5. Using 3/8-inch wrench, screw on and tighten capnut (8).

NOTE

Follow-on Maintenance Action Required:

Start engine and check operation of wiper motor. Refer to

TM 9-2320-211-10.

END OF TASK

19-24