 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-20-3-2
FRAME 2
1.
Turn over hub and brake drum assembly (1) as shown.
2.
Put inner wheel bearing cone (2) in hub (3).
3.
Put seal (4) into hub (3) as shown.
Using hammer and brass drift, lay brass drift on top of seal (4) as shown. Tap
4.
brass drift until seal is in hub (3).
5. Using hammer and brass drift, tap sides of seal (4) evenly all around until it
is seated inside hub (3).
6. Using clean rag, wipe off all grease around hub (3) and top of seal ( 4).
NOTE
Follow-on Maintenance Action Required:
Replace front hub and brake drum. Refer to para 13-3.
END OF TASK
13-42
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals