FRAME 2 - TM-9-2320-211-20-3-10823

TM 9-2320-211-20-3-1

FRAME 2

Using 3/8-inch wrench, unscrew bleeding screw (1) 3/4 turn. Look for air

bubbles in hydraulic fluid in container (2).

When there are no air bubbles in hydraulic fluid for five seconds, using

3/8-inch wrench, tighten bleeding screw (1).

Take bleeding hose (3) and 3/8-inch wrench off of bleeding screw (1). Take

bleeding hose out of container (2) and dump hydraulic fluid in contaminated

oil container. Do not dump fluid on ground.

Make sure that bleeding screw (1) is screwed on tightly.

NOTE

If air bubbles are seen when bleeding master cylinder,

do not disconnect bleeder tank from master cylinder as

air hydraulic cylinder and all wheel cylinders must be

bled. If no air bubbles were seen, do step 5.

Disconnect bleeder tank from master cylinder (4). Refer to para 12-14e.

END OF TASK

12-91