FRAME 8 - TM-9-2320-211-20-3-10779

TM 9-2320-211-20-3-1

Turn brake drum (1) until inspection hole (2) is at bottom of right brake

lining.

Put 0.010-inch feeler gage in inspection hole (2) so it is between brake

lining (3) and inside of brake drum (4).

If feeler gage just slides in, take out feeler gage, put cover on inspection

hole (2), then go to frame 9. If feeler gage does not just slide in, go to

step 4,

Using 1 1/16-inch open end wrench, loosen and hold anchor pin locknut

(5). Using 1/2-inch open end wrench, turn anchor pin (6) to the left

until feeler gage just slides in.

Using l/2-inch open end wrench, hold anchor pin (6). Using 1 1/16-inch

open end wrench, tighten locknut (5).

GO TO FRAME 9

12-47