FRAME 4 - TM-9-2320-211-20-3-10759

TM 9-2320-211-20-3-1

FRAME 4

Using screwdriver and 9/16-inch wrench, loosen locknut (1).

Slide feeler gage (2) between lower edge of inner brakeshoe (3) and brake

drum (4).

3. While sliding feeler gage (2) up and down, turn eccentric screw (5) until

gage barely slips at tightest point.

4. Check upper edge clearance. If needed, adjust upper clearance again. Go

back to frame 3.

5. When upper and lower edge clearances are the same, using 9/16-inch wrench,

tighten locknut (1).

6. Using torque wrench, tighten locknut (1) to 38 to 42 pound-feet.

END OF TASK

12-27