FRAME 3 - TM-9-2320-211-20-3-10710

TM 9-2320-211-20-3-1

Slide off four bearings (1) with cork washers (2) and dust shields (3). Throw

away cork washers.

Using 9/32-inch wrench, unscrew and take out lubrication fitting (4).

Dry cleaning solvent is flammable. Do not use near

an open flame. Keep a fire extinguisher nearby

when solvent is used. Use only in well-ventilated

places. Failure to do this may result in injury to

personnel and damage to equipment.

Clean all parts in solvent. Let parts soak in solvent for a short time.

Using small stiff brush, take off any dirt that is left.

Eye shields must be worn when using compressed

air. Eye injury can occur if eye shields are not

used.

5. Rinse all parts in clean solvent and dry then with compressed air. Cover

parts to keep them clean.

GO TO FRAME 4

10-84