Remove - TM-5-5420-279-230851

TM 5-5420-279-23

Remove

(1)

Deploy the A-Frame and stabilizer legs.

(2)

Support the weight of the slide frame at section three (1).

(3)

Disconnect the launch system from the vehicle. See operator's manual TM 5-5420-279-10.

(4)

Remove the stop pads (6) of section two (7 and 2). See unit maintenance procedure 5-080.

(5)

Remove section one (5 and 3) of the slide frame. See direct support maintenance

procedure 6-032.

(6)

Remove the stop pads (8) of section three (9 and 10). See unit maintenance procedure

5-081.

(7)

Remove section two (7 and 2) of the slide frame.

(8)

Check the component parts of section two.

(9)

Replace parts as required.

(11)

If required remove the screw (11) and remove the wear pad (12), there is another wear pad

fitted to the bottom of section 2 (7 and 2).

(10)

Remove the two screws (14) and side wear pad (13), there is another side wear pad fitted

on the opposite side of section 2 (7 and 2).

6-107