Install - TM-5-5420-279-230496

TM 5-5420-279-23

(19)

If required, to remove the shoot bolt turn the shoot bolt handle (15) counter-clockwise and

slide the shoot bolt from its housing.

Install

(1)

Apply thread-locking compound to all screws.

(2)

Fit the center post (3) to the crossbeam.

(3)

Fit the center post lower pin (14).

(4)

Fit the lower pin keep plate (13) and secure with two washers and screws (12).

(5)

Fit the telescopic tubes (10) to the center post (3).

(6)

Fit the telescopic tubes upper pins (11).

(7)

Fit the telescopic tubes upper pins keep plates (8).

(8)

Secure the keep plates with screws and washers (9).

(9)

Fit the micro-bore pipes (4) to the pumps (5) in the positions noted during removal.

(10)

Fit the micro-bore guard (2) with four nuts, bolts and washers.

(11)

Fit the hydraulic pipes (6) from the hydraulic reservoir (7) to the pumps (5).

(12)

Fit the hydraulic reservoir (7).

(13)

Fit the upper sliding section of the center post (1).

(14)

If the shoot bolt was removed earlier, place the shoot bolt in its housing and fit the shoot

bolt handle (15) to the shoot bolt.

(15)

Engage the shoot bolts.

(16)

Ensure that the far bank support is vertical.

(17)

Top up the far bank support hydraulic reservoir (7) and bleed the system; refer to unit

maintenance procedure 5-075.

(18)

Fit the far bank support to the forward launch beam; refer to unit maintenance procedure

5-074.

(19)

Fit the bearing pads, refer to unit maintenance procedure 5-073.

Follow on task

(1)

Check the operation of the far bank support.

5-240