Service - TM-5-5420-279-230485

TM 5-5420-279-23

Service

(1)

The rope guide roller (4) is made up of three sections. If the one section has excessive

wear or damage from the winch rope, one of the outer sections may be swapped with the

worn or damaged section. This may only be carried out once, then the rope guide roller (4)

must be completely replaced.

Remove

(1)

Deploy the far bank carriage lower pulley block (1) to gain access to the rope guide roller

(4).

(2)

Remove the spring pins (2).

(3)

Remove the roller shaft (3).

(4)

Remove the rope guide roller (4).

(5)

Check the spring pin and roller shaft for damage and wear.

(6)

Change components as required.

Install

(1)

Place the rope guide roller in the lower pulley block (1).

(2)

Fit the roller shaft (3) through the lower pulley block (1) and the rope guide roller (4).

(3)

Fit the spring pins (2).

(4)

Check that the rope guide roller is free to rotate.

(5)

Stow the lower pulley block (1).

5-229