Section V. DISPOSITION INSTRUCTIONS

Section IV. - COMPUTATION OF REPAIR COST ESTIMATES

8. Cost Factors. Refer to paragraphs 10 through 15,

11, DA Form 2407, (Maintenance request) to compute

direct labor and direct materials cost. Indirect expense

AR 750-27 for explanations of cost factors to be

considered when computing repair cost estimates.

and other charges, that are applicable, are added to

direct labor and direct materials cost to obtain the total

estimated repair cost.

9. Procedure. Results of the technical inspection

recorded on DA Form 2404 are transferred to Section

Section V. DISPOSITION INSTRUCTIONS

c. Request for disposition instructions will be

10. Eligibility of Material for Evacuation to Depot

prepared in accordance with AR 755-1.

Maintenance. All equipment covered by this bulletin is

eligible for evacuation to depot maintenance when the

d. Report of unserviceable excess items on DD

repairs required are beyond the capability of support

Form 1348-M-3, (DOD Single Line Item Detail Billing

maintenance and the cost of repairs will not exceed the

Card) will be accompanied by a completed DA Form 5-

one-time repair expenditure limits.

23 (Item Data Sheet for Engineer Equipment) in three

copies for each major item.

11. Disposition Instructions. a. Items will be reported

to the NICP for disposition instructions under the

e. Equipment will not be reported for disposition

following activities.

instructions solely on the basis that it is over-age.

Serviceable over-age equipment will be retined in use,

(1) The estimated one-time repair cost

unless priority of organization's mission warrants a

exceeds the prescribed expenditure limits and waiver of

replacement. Repairs to over-age equipment will be

limits is not authorized as provided for in paragraph 6b,

limited to the maintenance necessary to maintain it in a

AR 750-27.

safe, operable condition.

(2) The repairs required to restore an item to

f. Disposition of items in CONUS depot stock will

a serviceable condition are beyond the capabilities of

be determined by the NICP.

General Support Maintenance regardless of estimated

repair cost, except as provided for in "b" below.

12. References.

Depot repair is authorized in overseas

AR 750-27

SB 700-20

Commands without referral to NICP when repairs can be

SC 7900-ML

TM 38-750

accomplished within the prescribed expenditure limits.

APPENDIX A

13. Explanation of Columns. a. Column 1. FSC or

Stock Number; End Item Federal Stock Numbers listed

e. Column 5. Serial No. Range or USA Number;

in numerical sequence.

The serial number ranges for the production years listed

in column four.

b. Column 2. Item identification; Item generic

nomenclature, functional capability, make and model.

f. Column 6. Years of Life Expectancy; The

average life expectancy of the item in years.

Column 3.

Serial or USA Number

Identification and Remarks! This column contains

g. Column 7 through 13. Repair limitation; The

remarks when required to explain data in columns four

limiting year as it appears in these columns is intended

and five.

to represent the actual age of the equipment. Example:

If in column 7 the entry "1-3 yrs" appears, this means

d. Column 4. Production year; The year that item

that from the first year of service until the third year of

was manufactured. If no data is shown, refer to

service 65% of the end item cost is allowed for repair.

equipment data plate or equipment log book.