Section B - Calibration Support Capability

TB 750-25

(8) Block 15 - TMDE Type. Check SP (special purpose) block if the item is

designed for support of, and is functionally restricted to, only one system or end item;

otherwise, check GP (general purpose) block.

(9) Blocks 16a-c - Instrument Specifications. Block 16a - Enter the parameters

that denote the capabilities of the instrument (resistance, voltage, frequency, etc.). Block

16b - Enter the range of each parameter (0-100 MΩ, 0-1 V, 10-20 MHz, etc.). Block 16c -

Enter the accuracy of each range of each parameter. Entries in blocks 16a-c may be

omitted if the specification sheet for the instrument is attached (attachment of

specification sheet is preferred), in this case enter in block 16a "See Attached."

(10) Blocks 17a-d - Quantity fielded. When this form is completed by materiel

managers prior to fielding of a system, enter the number planned for delivery to each

theater (a-d).

c. Section B - Calibration Support Capability.

Section B will be completed as

follows:

(1) Blocks 18a through 19d are to be completed by the TMDE support coordinator

in cooperation with the chief of the C&RS organization.

(2) Blocks 20, 21, 23 and 24 are to be completed by the USATA.

(a) Block 20a-b - Select appropriate box that indicates the responsibility and

calibration repair.

(b) Block 21 - Enter the manual used to accomplish calibration, (e.g., TB, TM,

or manufacture's manual).

determined by the TSA.

(d) Block 24 - Select the block that indicates the action as related to TB 43-

180.

(3) Block 22 - System code should be completed by the owner/user initiating the

form.

(4) Block 25 - Remarks as appropriate.

(5) Blocks 26a through 26d are to be completed by the individual initiating the

form.

B-3