END HOUSING AND ROTOR ASSEMBLY .

TM 9-2920-225-34

2-9. END HOUSING AND ROTOR ASSEMBLY .

TOOLS: No special tools required

SUPPLIES :

End housing preformed packing

Lip seal (2)

Sleeve seal

Ball bearing and roller bearing grease, MIL-G-18709

PERSONNEL:

One

EQUIPMENT CONDITION : Generator removed from vehicle, pulley removed from

generator.

a. Preliminary Procedures.

(1) Clean generator before disassembly. Refer to para 1-3.

(2) Remove drive end bell and regulator assembly. Refer to para 2-8.

(3) Remove fan and hub assembly. Refer to para 2-7.

Removal.

FRAME 1

Take out six screws (1) .

NOTE

Scribe a mark from end housing (2) to intermediate

housing (3) so that housings can be put back the

same way.

Take end housing (2) and rotor (4) assembly out of intermediate housing ( 3).

NOTE

When rotor (4) is taken out, brushes will fall out

at drive end of intermediate housing (3). Take

out brushes.

END OF TASK

TA103550

2-49