This task is the same for the front and rear rocker arm
a s s e m b l i e s . T h i s task is shown for the front rocker arm
L o o s e n six adjusting screw locknuts (1) on front rocker arm assembly (2).
T u r n six adjusting screws (3) as far to the left as they will go.
P u t front rocker arm assembly (2) on front cylinder head (4). Six mounting
h o l e s (5) in rocker arm assembly must line up with six holes (6) in cylinder
P u t in and hand tighten two screws and lockwashers (7), Put in and hand
t i g h t e n two screws and lockwashers (8). Put in and hand tighten two
screws and lockwashers (9).
U s i n g torque wrench, tighten two screws (7) to 44 pound-feet. Using torque
wrench, tighten two screws (8) to 44 pound-feet. Using torque wrench,
t i g h t e n two screws (9) to 44 pound-feet.
D o steps 1 through 4 again on rear cylinder head (10).
GO TO FRAME 4