M a i n bearing lower halves and main bearing caps were
m a r k e d during removal. They must be put back in the same
p o s i t i o n and facing the same way. Failure to do this will
r e s u l t in damage or wear to engine.
C o a t four main bearing caps (1) and four main bearing lower halves (2) with
P u t four main bearing lower halves (2) into four main bearing caps (1). Put
f o u r main bearing caps into cylinder block (3). Put in eight cap screws with
Tighten eight capscrews (4) to 80 to 90 pound-feet. Tighten eight capscrews
t o 120 to 125 pound-feet.
GO TO FRAME 10