Replacement of Expansions Plugs, Pipe Plugs, and Crankcase to Cylinder
If expansion plug (1) behind identification plate (2) was taken out, coat
n e w e x p a n s i o n p l u g w i t h s e a l e r . T h e n knock in new expansion plug using
m a l l e t and short brass rod until they are about 1/8-inch below surface of
L i n e up four holes in identification plate (2) with mounting holes for
i d e n t i f i c a t i o n plate in crankcase (3). Using hammer, tap in four straight
P u t in crankcase to cylinder head studs (5).
GO TO FRAME 2