Main bearing caps (1) with bearing halves (2) and main
b e a r i n g saddles (3) are called by numbers one to seven
c o u n t i n g from front to rear of crankcase (4).
N u m b e r two main bearing cap (1) has a flat mounting
s u r f a c e (5) for mounting the oil pump.
P u t number two main bearing cap (1) with bearing half (2) on number two
m a i n bearing saddle (3). Mounting holes in number two main bearing cap
m u s t line up with screw holes in number two bearing saddle.
C o a t two bolts (6) and washers (7) lightly with engine lubricating oil. Put
i n and hand tighten two bolts and washers.
U s i n g torque wrench, tighten two bolts (6) to 80 to 90 pound-feet.
U s i n g torque wrench, tighten two bolts (6) to 115 to 120 pound-feet.
GO TO FRAME 62