Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
Number five main bearing cap (1) is marked with the num-
Put number five main bearing cap (1) on number five bearing saddle (2).
Mounting holes in number five main bearing cap must line up with screw
h o l e s in number five bearing saddle.
C o a t two bolts (4) and washers (5) lightly with engine lubricating oil. Put
i n and hand tighten two bolts and washers.
U s i n g torque wrench, tighten two bolts (4) to 80 to 90 pound-feet.
U s i n g torque wrench, tighten two bolts (4) to 115 to 120 pound-feet.
GO TO FRAME 51