Main bearing caps (1) and bearing saddles (2) are called
by numbers one to seven counting from front to rear of
The number one main bearing cap (1) has oil pump idler
gear shaft (4).
Put number one main bearing cap (1) on number one bearing saddle (2) with
o i l pump idler gear shaft (4) facing out as shown.
C o a t two bolts (5) and washers (6) lightly with engine lubricating oil. Put
i n and hand tighten two bolts and washers.
U s i n g torque wrench, tighten two bolts (5) to 80 to 90 pound-feet.
U s i n g torque wrench, tighten two bolts (5) to 115 to 120 pound-feet.
GO TO FRAME 43