Belt Take-Up Bracket Installation.

TM 9-2320-366-20-3

7-4. ALTERNATOR BRACKETS REPLACEMENT (CONT)

d. Belt Take-Up Bracket Installation.

(1) Position alternator belt take-up mounting bracket (1) on

engine front cover (2) with two screws (3).

(2) Position three screws (4) in engine front cover (2).

(3) Tighten two screws (3) to 121-147 lb-ft (164-200 Nm).

(4) Tighten three screws (4) to 106-130 lb-ft (144-176 Nm).

(5) Install alternator belt take-up plate (5) on alternator belt

take-up mounting bracket (1) with washer (6) and screw

(7).

(6) Install washer (8) and screw (9) in alternator belt take-up

plate (5).

NOTE

Steps (7) and (8) require the aid of an assistant.

Use square hole in water pump belt pulley

bracket to apply and maintain tension on water

pump belt while adjusting belt tension.

(7) Adjust tension on water pump belt (10) to 80-100 lbs

(356-444 N).

(8) Tighten two screws (11) to 35 lb-ft (47 Nm).

7-18