 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-3
WARNING
Drop hydraulic pressure to zero before
disconnecting any hydraulic hoses. Failure
to comply may result in injury to
personnel.
Hydraulic fluid (MIL-H-5606) is TOXIC.
Wear protective goggles and gloves; use
only in well ventilated area; avoid contact
with skin, eyes, and clothes. Skin and
clothing that come into contact with
hydraulic fluid should be washed
immediately. Saturated clothing should be
removed immediately. Failure to comply
may result in injury to personnel.
Compressed air used for cleaning purposes
will not exceed 30 psi (270 kPa). Use
only with effective chip guarding and
personal protective equipment (goggles,
shields, gloves, etc.). Failure to comply
may result in injury to personnel.
NOTE
Perform steps (1) through (12) on
hydraulic manifolds installed on vehicles
S/N 001 through 7558.
(1) Remove pin from hydraulic manifold cover
and lower cover.
(2) Cycle FUNCTION SELECT knob through all
settings.
(3) Cycle CAB TILT knob through both
selector settings.
(4) Remove screw, knob, and CAB TILT valve
from hydraulic manifold.
(5) Remove orifice filter (if equipped) from
hydraulic manifold.
(6) If debris is present in orifice filter, replace
orifice filter.
(7) Remove orifice screw from hydraulic
manifold.
(8) If debris is present in orifice screw, clean
orifice screw with compressed air.
NOTE
If no orifice filter was previously installed,
orifice filter will be installed at this time.
(9) Install orifice screw and orifice filter in
hydraulic manifold.
(10) Position CAB TILT valve and knob on
hydraulic manifold with screw.
(11) Tighten screw to 5-15 lb-in. (1-2 Nm).
(12) Close hydraulic manifold cover and
install pin.
Cont. on page 2-2414.11.
Change 1
2-2414.9/(2-2414.10 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals