WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DISPLAYS MAIN CODE 13 AND ANY SUB CODE (cont)

TM 9-2320-366-20-2

CAUTION

Loose or dirty connectors may cause

intermittent loss of power to transmission

ECU and diagnostic codes to be logged.

Ensure that all connectors are clean and tight

before performing troubleshooting. Failure to

comply may result in incorrect test results.

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes. Failure to comply

may result in damage to equipment.

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability. Check that

connector pins are not pushed back and

are capable of making good contact.

(1) Check to see if main code 13 sub code 12 is

active in WTEC III TPSS (para 8-5).

(2) If main code 13 sub code 12 is not active in

WTEC III TPSS, go to step 7 of this fault.

Change 1

2-1807