Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
Set multimeter to ohms.
Connect positive (+) probe of multimeter to
WTEC II connector pin L2.
Connect negative (-) probe of multimeter to
WTEC II connector pin K2 and note reading
If continuity is not present, replace WTEC
II VIM (para 8-6).
Connect connector PX33 to WTEC II VIM.
Tighten screw in connector PX33.