Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
Disconnect batteries (para 7-57).
Set multimeter to ohms.
Connect positive (+) probe of multimeter to
connector PX33 socket K1.
Connect negative (-) probe of multimeter to
connector PX33 socket K2 and note reading
If continuity is not present, Repair wires
3101 and 3102 from connector PX33
sockets K1 and K2 to terminal board TB2
position 16 and 17 (para 2-45) or replace
WTEC II dashboard cable assembly