 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1) Lower cab (TM 9-2320-366-10-1).
(2) Remove two screws and washers from
front grille.
(3) Remove screw and washer from front
grille.
(4) Remove front grille from cab.
(5) Remove instrument panel assembly for
access (para 7-15).
(6) Disconnect connector J114 (bottom
connector) at WTEC II TEPSS.
(7) Set multimeter to ohms.
(8) For each line of Table 2-27. WTEC II Cab
Transmission Harness Continuity Check:
(a) Install jumper wire across sockets in
column 1.
(b) Connect positive (+) probe of
multimeter to socket in column 2.
(c) Connect negative (-) probe of
multimeter to socket in column 3 and
note reading on multimeter.
(9) If continuity is not present on any wire in
Harness Continuity Check, replace WTEC II
cab transmission harness (para 7-137).
(10) Remove jumper wire from connector J119.
Continuity Check
Column 2
COLUMN 3
Column 1
Positive (+)
Negative (-)
Jumper Across:
Probe to:
probe to:
J119f to J119Z
J115-1
J115-22
J119Z to J119R
J115-1
J114-24
J119f to J119R
J115-22
J114-24
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals