 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1) Remove instrument panel assembly for
access (para 7-15).
(2) Disconnect connector J115 (top connector)
from WTEC II TEPSS.
(3) Install jumper wire from connector J119g
to J119n.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to connector J115-5.
(6) Connect negative (-) probe of multimeter to
connector J115-14 and note reading on
multimeter.
(7) Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and note reading on multimeter.
(8) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(9) Connect positive (+) probe of multimeter
to connector J115-14.
(10) Connect negative (-) probe of multimeter to
all other sockets in connector J115 (except
J115-5), one at a time, and note reading on
multimeter.
(11) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(12) If continuity is not present in step 6, or
continuity is present in step 7, 8, 10, or
11, replace WTEC II cab transmission
harness (para 7-137).
(13) If continuity is present in step 6, and
continuity is not present in steps 7, 8, 10,
and 11, replace WTEC II TEPSS (para 8-2).
(14) Remove jumper wire from connector J119.
(15) Connect connector J115 to WTEC II TEPSS.
(16) Install instrument panel assembly (para 7-15).
(17) Connect connector P119 to connector J119.
(18) Position front grille on cab with washer and
screw.
(19) Position two washers and screws in front
grille.
(20) Tighten screw to 48-60 lb-in. (5-7 Nm).
(21) Tighten two screws to 24 lb-in. (3 Nm).
(22) Clear diagnostic codes (para 8-4).
Change 1
2-1605
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals