 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove personnel heater to gain access
(para 18-9).
(2)
Disconnect connector P913 from connector
J913.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
connector J913-2.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, repair wire 1674
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8)
If 12 vdc is present, repair wire 1674
(para 2-45) or replace auxiliary panel cable
assembly (para 7-58).
(9)
Position master power switch to off
(TM 9-2320-366-10-1).
(10)
Connect connector P913 to connector J913.
(11)
Install personnel heater (para 18-9).
(12)
Connect connector P906 to blackout override
switch.
(13)
Position auxiliary panel on auxiliary panel
housing with six screws.
(14)
Tighten six screws to 24 lb-in. (3 Nm).
2-1571
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals