 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove relay K12 from PDP.
(3)
Set multimeter to volts DC.
(4)
Connect positive (+) probe of multimeter
to PDP, where relay K12 terminal 86 was
removed.
(5)
Connect negative (-) probe of multimeter
to ground.
(6)
Position main light switch to STOP LIGHT
(TM 9-2320-366-10-1) and note reading on
(7)
If 12 VDC is not present, repair wire 1673
from relay K12 terminal 86 on PDP to
connector J913 pin 1 (para 2-45) or replace
WTEC II dashboard cable (para 7-10) or
WTEC III dashboard cable assembly
(para 7-11).
(8)
Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-1545
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals