(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
worklights switch terminal 1.
(3) Connect negative (-) probe of multimeter to
worklights switch terminal 5.
(4) Position worklights switch to on
(TM 9-2320-366-10-1) and note reading on
(5) If continuity is not present, replace
worklights switch (para 7-18).
(6) Connect connector P905 to worklights
(7) Position auxiliary panel on auxiliary panel
housing with six screws.
(8) Tighten six screws to 24 lb-in. (3 N·m).