Click here to make tpub.com your Home Page

Page Title: CONTINUITY TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Disconnect connector P172 from connector
J172.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to connector P172 socket H.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3084 from connector P172 socket H to
terminal lug TL77 (para 2-45) or replace
M1090/M1094 dump power cable
assembly (para 7-125).
(6) If continuity is present, repair wire 3084
from connector J172 pin H to connector
L9 socket 2 (para 2-45) or replace
M1090/M1094 dump cable assembly
(para 7-124).
(7) Connect connector P172 to connector
J172.
(8) Connect connector L9 to solenoid valve.
(9) Tighten screw in connector L9.
(10) Lift dump body.
(11) Place maintenance legs in stowed position.
(12) Lower dump body.
(13) Remove cargo sling from two dump body
lifting brackets.
(14) Remove two dump body lifting brackets
from dump body.
(15) Position two locking pins in dump body.
(16) Install safety pin in two locking pins.
Change 1
2-1497

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business