Wear appropriate eye protection when working
under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to
Dump body weighs approximately 3,034 lbs
(1,376 kgs). Attach a suitable lifting device
prior to lifting. Failure to comply may result
in injury to personnel or damage to equipment.
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Raise dump bed (TM 9-2320-366-10-1).
Loosen screw on connector L7.
Disconnect connector L7 from tailgate
Set multimeter to volts DC.
Connect positive (+) probe of multimeter
to connector L7 socket 1.
Connect negative (-) probe of multimeter
Press and hold tailgate release switch
(TM 9-2320-366-10-1) and note reading
If 24 VDC is not present, go to step 3 of