 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Install circuit breaker CB50 in PDP.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to terminal block TB9.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If 24 VDC is not present, go to step 15 of
this fault.
(6) If 24 VDC is present, replace M1089
control panel wiring harness (para 7-83)
and STATION SELECTOR switch
(para 7-34).
NOTE
Perform steps (7) and (8) if 24 VDC is
present at terminal block TB9.
(7) Install PDP cover (para 16-2).
(8) Install wrecker control panel top cover
(para 14-4).
Change 1
2-1450.19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals