Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
Remove cover from left or right remote control
cable bulkhead connector.
Set multimeter to volts dc.
Connect positive (+) probe of multimeter to
pin E of remote control bulkhead connector.
Connect negative (-) probe of multimeter to
pin B of remote control bulkhead connector.
Position MAIN POWER switch to ON
(TM 9-2320-366-10-1) and note reading on
If 24 vdc is not present, relace left or right
remote control cable (para 7-115 or 7-118).