VOLTAGE TEST - TM-9-2320-366-20-20271

TM 9-2320-366-20-2

WARNING

Remove rings, bracelets, watches,

necklaces, and any other jewelry

before working around vehicle.

Jewelry can catch on equipment

and cause injury or short across

electrical circuit and cause severe

burns or electrical shock.

VOLTAGE TEST

(1)

Remove instrument panel assembly for access

(para 7-15).

(2)

Disconnect connector J43 from connector P43.

(3)

Set multimeter to volts dc.

(4)

Connect positive (+) probe of multimeter to

connector J43-9.

(5)

Connect negative (-) probe of multimeter to

ground.

(6)

Position master power switch to on

(TM 9-2320-366-10-1) and note reading on

multimeter.

(7)

If 24 vdc is not present, repair wire 1481

(para 2-45) or replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III dashboard

cable assembly (para 7-11).

(8)

If 24 vdc is present, repair wire 1481

(para 2-45) or replace start and charging

cable assembly (para 7-132).

(9)

Position master power switch to off

(TM 9-2320-366-10-1).

(10)

Connect connector J43 to connector P43.

(11)

Install instrument panel assembly (para 7-15).

2-1147