 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
connector P36-2.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If 24 vdc is not present, go to step 4 of this
fault.
(6)
Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector P36-1.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, go to step 5 of this
fault.
(5)
If continuity is present, fault corrected.
(6)
Connect connector P36 to water temperature
switch connector.
(7)
Connect connector clamp on water
temperature switch connector.
2-1097
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals