 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
CONTINUITY TEST
(1)
Remove three screws and washers from PDP.
(2)
Remove three screws from PDP.
(3)
Lift PDP outward to gain access.
(4)
Disconnect connector J7 from WTEC II TEPSS
dimmer module.
(5)
Set multimeter to ohms.
(6)
Connect positive (+) probe of multimeter to
connector J7-4.
(7)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(8)
If continuity is not present, repair wire 158
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10).
2-1063
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals