Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
Raise cab (TM 9-2320-366-10-1).
Lift dust boot from terminal lug TL60.
Set multimeter to volts DC.
Connect positive (+) probe of multimeter to
terminal lug TL60.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If 12 VDC is not present, replace 100 AMP
cable (para 7-72) or replace 200 AMP
alternator to terminal block 12 VDC
cable (para 20-48).
(7) Position dust boot on terminal lug TL60.