 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1) Connect connector P110 to CTIS ECU.
(2) Remove instrument panel assembly for
access (para 7-15).
(3) Disconnect connector J43 from connector
P43.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
connector J43 socket 2.
(6) Connect negative (-) probe of multimeter to
connector J111 socket F and note reading
on multimeter.
(7) If continuity is not present, repair wire
1790 from connector J43 socket 2 to
connector J111 socket F (para 2-45) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) If continuity is present, repair wire 1790
from connector P43 pin 2 to connector P84
socket B (para 2-45) or replace start and
charging cable assembly (para 7-132).
(9) Connect connector P43 to connector J43.
(10) Install instrument panel assembly (para
7-15).
(11) Connect connector J111 to connector P111.
(12) Install kick panel (para 16-3).
Change 2
2-958.17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals