 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector P84 socket A.
(3) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3032
from connector P84 socket A to terminal lug
TL85 (para 2-45) or replace start and
charging cable assembly (para 7-132).
(5) Connect connector P84 to air pressure
switch.
CONTINUITY TEST
(1) Disconnect connector P110 from CTIS ECU.
(2) Remove kick panel (para 16-3).
(3) Disconnect connector P111 from connector
J111.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
connector P111 pin F.
(6) Connect negative (-) probe of multimeter to
connector P110 socket T and note reading
on multimeter.
(7) If continuity is not present, replace CTIS
cable assembly (para 7-60).
Change 2
2-958.15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals